+ Reply to Thread
Results 1 to 2 of 2

Thread: C Band 2.4M Dish install

  1. #1
    Junior Member
    Join Date
    Feb 2016
    Location
    OZ
    Posts
    6

    Default C Band 2.4M Dish install

    Hi guys just installing a C Band 2.4M dish, Ive got all the information from dish pointer which i know is just a guide but on the Elevation what part of the dish has to be used for? The mount, The actual dish or what exactly

    Heres a picture of what my mount looks like
    http://imgur.com/a/tSUkQ


    Regards

  2. #2
    Senior Member
    Join Date
    Dec 2015
    Location
    Christchurch
    Posts
    409

    Default

    The elevation is the angle between the ground and the line through the center of the dish.

    Adjust the dish mount so a spirit level shows that angle.

    Then connect you STB and TV and manually add the transponder info into your STB for a good TP from the sat you are pointed at.
    Then move the dish around a little until you get a signal level on your STB / TV. Or use a sat finder.

    Check that you have the LNB rotated (Skew) correct.
    You can try swapping the TP info from H to V and try moving the dish again if you think your LNB may be set wrong.

    Good luck

    Owen

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts